This instruction show you guide on how to replace sealing strip and valve cover for Volvo VN truck.Illustrations may differ slightly from the actual vehicle being serviced. However, key components addressed in this information are represented as accurately as possible.
Related Contents:
2022 Volvo PTT Premium Tech Tool PTT 2.8.150 & 2.7.116 Free Download
Volvo Impact 2021 2019 EPC Parts Catalogue Free Download
Procedures:
1.Disconnect the connectors.
2.Loosen the screws.
3.Remove the frame.
4.Remove the gasket.
5.This step contains 2 alternatives.
Select one of the valid alternatives below.
Alternative 1 / 2
Remove the old sealant from the contact surfaces (A).
Note:Ensure that the surfaces are completely clean from sealant.
Note:Ensure that the sealant on the timing gear plate is not damaged (B).
Perform this procedure when the condition below is met.
Conditions
Timing gear plate without integrated sealing
▶
Apply sealant.
Tech data Sealant, bead thickness 2 mm
Note:Use recommended sealant.
Note:Install the valve cover within 20 minutes of applying the sealant.
Perform this procedure when the condition below is met.
Conditions:Timing gear plate with integrated sealing
Apply sealant.
Tech data Sealant, bead thickness 2 mm
Note:Use recommended sealant.
Note:Install the valve cover within 20 minutes of applying the sealant.
Clean the contact surfaces carefully.
▶Clean the groove.
Note:Ensure that the surfaces are completely clean from oil and grease.
Install the gasket
Note Use a new part.
Install the frame.
Torque tighten the screws.
Tightening torque
Lower valve cover, screw
Tightening sequence: 1-4 24 ±4 Nm
Connect the connectors.
For more Volvo Truck repair case,please refer to Volvo Truck Trouble Repair