Renault ATE ABS/ESC/CDC/ESP Mileage Correction by iProg Pro

This instruction show you guide on how to use iProg pro programmer to change odometer value for Renault ATE ABS/ESC/CDC/ESP by OBD.More Renault cases,please refer to:Renault Trouble Repair.

 

Preparations:

Newest iProg Pro Plus iProg+ v84 v82 Free Download

 

Procedures:

Connect iProg Plus programmer to Renault vehicle obd port.

Then run software to select “Renault_ATE_ABS_OBD2”

Click “Read EEPROM”

Renault-ATE-ABSESCCDCESP-Mileage-Correction-by-iProg-Pro-1

Then reading data done,it will show you current milage:94313

Renault-ATE-ABSESCCDCESP-Mileage-Correction-by-iProg-Pro-2

Input new value:12345

Click “Change KM”,then click “Write EEPROM”

Renault-ATE-ABSESCCDCESP-Mileage-Correction-by-iProg-Pro-3

It will ask you if write whole EEPROM or modified bytes

Click “No” to write modified bytes only

Renault-ATE-ABSESCCDCESP-Mileage-Correction-by-iProg-Pro-4

After writing done,click “Read EEPROM” again to check if new value KM is valid

Renault-ATE-ABSESCCDCESP-Mileage-Correction-by-iProg-Pro-5

(Visited 48 times, 2 visits today)