Here car-auto-repair.com show the procedures to disable or active passenger airbag for VW.Hope it helps!
Preparations:
How to Install VCP System Diagnostic Tool Software
VCP System Professional Diagnostic Tool Software Download
Procedures:
Connect VCP interface to vehicle,then inter menu to select “Guided function assist”
Select “Airbag” at right section and select “Deactivation passenger airbag”
The procedures for the passenger airbag off.
WARNING! Is also required physical separation of airbag otherwise the ECU will report an error “too high resistance”
Condition on
Here you can select additional options:Turn on or Turn off
Click “Next” to start the processing…
Done!
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…