Here is the instruction show you guide on how to solve AGCO machine trouble code trouble code 97 – SPN 100 – FMI 03 oil pressure sensor defect high and low error.
Related Contents:
AGCO 2×4 CANUSB Interface Diagnostics
AGCO EDT Electronic Diagnostic Tool
Oil Pressure Sensor Defect HIGH
The measured oil pressure signal is above the normal operating range (more than 4.7 V).
Failure Mode Indicator
FMI 03 – Voltage above normal or shorted to high source
Failure Mode
Fault code is stored and oil pressure warning lamp is activated. Engine power will be reduced (FL1). CAN message indicates active fault. Engine protection functions on oil pressure are not active.
IMPORTANT: Engine oil pressure protection is not active. The engine may be damaged, if oil pressure is too low.
Possible Cause
- Oil pressure sensor wiring is defective
- Oil pressure sensor power supply is not correct
- Oil pressure sensor is defective
- Control unit is defective
Diagnosis and Solution
Check the oil pressure sensor wiring, connectors and contact surfaces of the connector pins (possible oxidation).
Oil Pressure Sensor
Check the 5 V power supply to the sensor.
Oil Pressure Sensor
Check the oil pressure sensor operation.
Oil Pressure Sensor
Check the ECU operation with another EEM3 controller. If the system is functional and the fault is not active with the replacement ECU, then the original ECU is defective.
Oil Pressure Sensor Defect LOW
The measured oil pressure signal is below the normal operating range (less than 0.2 V).
Failure Mode Indicator
FMI 04 – Voltage below normal, or shorted to low source.
Failure Mode
Fault code is stored and oil pressure warning lamp is activated. Engine power will be reduced (FL1). CAN message indicates active fault. Engine protection functions on oil pressure are not active.
IMPORTANT: Engine oil pressure protection is not active. The engine may be damaged, if oil pressure is too low.
Possible Cause
- Oil pressure sensor wiring is defective
- Oil pressure sensor power supply is not correct
- Oil pressure sensor is defective
- Control unit is defective
Diagnosis and Solution
- Check the oil pressure sensor wiring, connectors and contact surfaces of the connector pins (possible oxidation).
Oil Pressure Sensor
- Check the 5 V power supply to the sensor.
Oil Pressure Sensor
- Check the oil pressure sensor operation.
Oil Pressure Sensor
- Check the ECU operation with another EEM3 controller. If the system is functional and the fault is not active with the replacement ECU, then the original ECU is defective.
ECU Replacement