When you repair bake system or replace brake fluid for Jaguar XF,you need to perform brake bleed.So this function show the procedures on how to use G-Scan 2 diagnostic tool to bleed brake system for Jaguar XF 3L diesel engine.And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.
Procedures:
Connect G-Scan 2 diagnostic tool to Jaguar XF by OBD port,then enter menu to select [Diagnosis]
JAGUARE–>Vehicle model:XF–>Year:2010-2011
ABS(ABS Control Module),then select [OK] to continue
Select [Special Function]–>[Brake Bleed]
Switch ignition to ON position [position 2]
Open the rear left wheel bleed screw
Pump the brake pedal during the entire bleed procedure.
Select [OK] to continue
Now press the brake pedal and wait the process…
When you finish the operation,it will show the massage on the screen
Wait until the brake fluid is air and bubble free
Close the rear left wheel bleed screw
Then select [OK] to continue
Open the front left wheel screw
Pump the brake pedal during the entire bleed procedure
Wait…
Wait until the brake fluid is air and bubble free.
Close the front left wheel bleed screw.
Open the front right wheel screw
Pump the brake pedal during the entire bleed procedure
Wait about 3 minutes to process complete
Wait until the brake fluid is air and bubble free.
Close the front right wheel bleed screw.
Open the rear right wheel bleed screw
Pump the brake pedal during the entire bleed procedure.
Wait…
Wait until the brake fluid is air and bubble free
Close the rear right wheel bleed screw
Now turn the ignition to OFF position,then press [OK] to continuef
Completed successfully
