This article show the guide on how to use VCP System to unlock and lock VW electronic handbrake.Hope it helps!
Preparations:
How to Install VCP System Diagnostic Tool Software
VCP System Professional Diagnostic Tool Software Download
Vehicle Supported:
All vehicles equipped with an electronic handbrake (STG53 – parking brake)
Procedures:
Connect VCP System interface to vehicle,then select “Guided functions assistant”
Select “Opening,closing electric handbrake”
The procedure open/closes the brake calipers on vehicles with electric emergency brake.
Conditions:
Ignition on
Before starting the procedure for opening please lock and then unlock the emergency brake.Closing does not require and additional action before starting.
It should be important to ensure that the communication was maintained between the VCP program and the car during the procedure.Noise (Low battery,cable damage etc) can result in damage to the control modules.
Here you can select additional options
Here you need select car models “Passat,Tiguan,Audi A6,Audi A7”,click “Next” to start processing.
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…