This instructions show a guide on how to use VCP system to perform basic setting for VW Xenon headlamp beam height.
Preparations:
How to Install VCP System Diagnostic Tool Software
VCP System Professional Diagnostic Tool Software Download
Vehicle Models Supported：
PQ35/46: Passat 3C, Audi A6 4F, Audi A8 4E
K-Line: Passat 3B, Audi A4 4E, Audi A6 4B
CAN UDS: A6 C7 / A8 D4
Procedures:
Connect your VCP interface to vehicle,then select “Xenon” and “Basic setting of Xenon range controller”
The procedure sets the Xenon headlights in the service position,so that they could be manually set.
Conditions:
Ignition on
The engine NOT running
Now you need to select your vehicle models
Then click “Next” to start processing
Done!
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…