ODIS Engineering Flashing Transmission DSG 7 DQ200 Unit

This article show a guide on how to us ODIS Engineering software to flashing Transmission DSG 7 DQ200 Unit.

 

What You Need:

VAS5054A

Newest ODIS-E Engineering 17.0.1/12.2.0/9.0.1 Free Download

08.2023 VW ODIS 23.0.5 & 7.2.1 & 5.2.7 Diagnostic Software Free Download

 

Procedures:

Connect VAS5054A to laptop and DSG 7 DQ200 unit,and supply power for DSG 7 DQ200 unit.

Run ODIS Engineering software,click “Admin” button at upper right corner.

Select “Function configuration” tag,then select “Flashing (Engineering)”

Make sure the options “UDS flash sessions” and “KWP control modules ” are not selected

Click the “Diagnosis” button at upper right corner to back to main views

Here i click “Vehicle project” to select “VwFLEET”,then click “Diagnostic Entrance” button

Then the ODIS Engineering software will load control modules as below

Select “042-Flash”

Select “0002-Transmission Control Module”,and click “Local flash file”

Select a file to load,and click “Start flashing”

It will prompt you warning massage as below,click “Yes” to continue

Do you want to flash all selected control modules?

Note:The flash process can take a long time when multiple containers are selected.

Make sure the power supply is sufficient

Switch the ignition off and on and then confirm this dialog

When it finish,it will prompt you “Would you like to clear all control DTC…”

Click “Yes” to continue

Done!