This article show a guide on how to use FORScan to enable auto fold for Ford F150,hope it helps!
What You Need?
FORScan Android/iOS/Window Free Download
How to Install & Configure FORScan for OHP ELMconfig
Procedures:
Connect your OHP Ford ELMconfig USB adapter to vehicle,then run FORScan on you laptop
Click “Connect to vehicle”
The FORScan will prompt you with the feedback needed massage,click “Yes” to continue
Then it will check your Ford F150 modules status as below
After then click the “Configuration and Programming” icon at left menu
Select “DDM”,then click “Run service procedure”
Prompt you with massage,just click “OK” to continue,
Then change the blocks values:
740-03-01:”A000 EB” to “A800 EB ”
740-12-01:”005A” to “F05A”
Click “Write All”
Click “Yes” to continue
Then stop service procedure,and back to the modules,then select “PDM” and click “Run service procedure”
Change the block 741-03-01 value “A000 EC” to “A800 EC”,block 741-12-01 value “005B” to “F05B”,click “Write All”
Block(s) programmed successfully,please cycle the ignition OFF and back ON
Done!
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…