How to Use FCA wiTECH J2534 Function on G-scan 3 for Jeep

This article is show you about FCA wiTECH J2534 on 2018 Jeep Renegade via G-scan.If you want to know more about G-Scan function, please refer to G-Scan test cases.

Steps:

Connect OBD 2 connector DLC cable between G-scan3 and the vehicle’s OBD2 port. And Turn IG ON.

Connect Micro 5 pin USB cable to G-scan3

Connect other end of the USB cable to OEM software installed laptop.

Hit “J2534” in the main menu and select “J2534 FOR OTHERS”

When critical function such as ECU reprogramming is going to be performed, use a J2534 device that is recommended by car manufacturer. Hit “Accept”

Launch the OE software and set G-scan as a J2534 device.

Make sure to connect the laptop to internet.

FCA factory software will ask you to sign in.

Once you are logged in, you’ll be able to diagnose the vehicle.

TechAuthority ID and Password is required for special functions in SGW modules.

 

For more project on Jeep,please check here:Jeep Trouble Repair.

Kevin

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

3 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago