Categories: How To

How to Connect Scania 4 Series CAN with Scania VCI 2

Scania 4 series do not have a coordinator and uses VCI 1 to connect to the vehicle to run SD2/SP2. To read engine data in real time with for example Scanina XCOM you have to connect to CAN with VCI 2. To do that you need a “homemade” VCI-cable, see below, and a software-fix to connect to the engine control unit (ECU).

 

Related Contents:

2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download

2023 2018 Scania Multi EPC Parts Catalogue Free Download

Scania VCI3 Interface

 

 

It also works with DMecNet, CDev, Gadget and other SCOMM based programs.

1.You need:

Standard CAN connector (Scania P/N 1349719)

4 cables (approx. 40cm)

2 alligator clip

Standard VCI connector

 

2.Connect the wires according to pictures

Pin 16 to red alligator clip

Pin 4 to black alligator clip

Pin 6 and 14 to CAN connector

 

3.Set the tester address and search mode in XCOM These changes will make XCOM, SDP3, Gadget, CDev and DMecNet to only scan for EMS on the CAN bus. No other ECUs will be found!

Open Options in XCOM (Options menu -> Options)

 

Set Tester address to “F9”

Change search mode to “S6 PRESAMM (Physical request ECU 0x00)”. Select OK on the warning.

Press OK to accept changes.

Restart XCOM

 

4.Connect the “Homemade” VCI cable to the vehicle under the fuse box. Connect VCI2 to the VCI connection.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

3 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

4 weeks ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago