Here is the instruction show you guide on how to solve Scania truck alarm system ALM259 Secondary wake-up signal,short circuit.
Related Contents:
2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2024 2018 Scania Multi EPC Parts Catalogue Free Download
Secondary wake-up signal, short circuit
Error identification
The secondary wake-up signal is short-circuited to ground.
Cause
Faulty cable harness for the secondary wake-up signal.
Faulty ALM control unit E7.
Notes
–
Symptom
The control unit cannot wake up or be woken up by units connected in the CAN network.
Action
Disconnect the harness-to-component connector to ALM control unit pin A3.
Measure for short circuits throughout the cable harness.
If there are several harness-to-component connectors between the wake-up signal and the control unit, disconnect them and measure to locate the fault.
If the fault is not in the cable harness it is probably an internal fault in the ALM control unit.
For more information about Scania truck,please refer to:Scania Trouble Repair.
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…
Here is the instruction show you guide on how to solve Caterpillar C9 fault code 64-2…