Categories: Auto Repair

How to Repair Audi Q5 Advance Key Defective Use Ignition Lock 03284 Trouble

This repair case share a real repair project on how to solve Audi Q5 smart key can not work problem.The instrument show massage “Advance Key Defective Use Ignition Lock”.For Audi repair,please check more cases here:Audi Trouble Repair Projects.

Preparation:

Newest ODIS-E Engineering 17.0.1/12.2.0/9.0.1 Free Download

08.2023 VW ODIS 23.0.5 & 7.2.1 & 5.2.7 Diagnostic Software Free Download

 

Diagnostics:

Use VW ODIS software to diagnose,it gave the error code:

03284–Antenna for Access & Start Authorization; Right

It mean that the smart key work fine,maybe the antenna get trouble.

The Audi Q5 equipped with 4 antenna,left rear door,right rear door,near gear shifter and into the trunk.According to the DTC–03284,we remove the right rear door antenna and exchange it with left rear antenna,but the trouble still exit.So it means that the antenna also work fine,maybe the related diagram work broken.

Measure the harness between right rear door and comfort module J393,it is ok.

The comfort module J393 located in the trunk,the blue connector is the bus of all antenna,remove the comfort module J393.

 

Accord to the antenna pins diagram to measure,mechanic found there are 4 triodes work for antenna.Now remove the triode work for right rear door antenna to replace a new one.

After then,install all parts back,then start vehicle,the trouble have been solved.

auto

Recent Posts

MANITOU MT6034 Telehandlers PWP System Deactivation Tests

This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…

2 days ago

How to Solve Liebherr Machine ECU2 P1119 SCR System Plausibility Error

This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…

4 days ago

Bobcat Machine P18A5 Suction Line Heater Open Error Solution

This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…

1 week ago

AGCO Machine SPN 102 – FMI 31 Intake Manifold Pressure Drop Too High at Cranking

The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…

2 weeks ago

JCB 3CX 4CX Backhoe Loader Engine Throttle Cable Removal and Replacement

JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…

2 weeks ago

How to Replace Fuel Tank Breather Filter Element for Liebherr R9600 Excavator

Here is the instruction show you guide on how to replace fuel tank breather filter…

1 month ago