How to Do 7 Speed DSG Basic Setting by ODIS on 2014 Skoda Octavia

This instruction will show you guide on how to do 7 speed DSG basic setting by ODIS for 2014 Skoda Octavia.

Preparation:

Newest ODIS-E Engineering 17.0.1/12.2.0/9.0.1 Free Download

08.2023 VW ODIS 23.0.5 & 7.2.1 & 5.2.7 Diagnostic Software Free Download

How to Install ODIS-Engineering 12.1.0 Diagnostic Software

Procedures:

Connect ODIS to vehicle OBD port, then running software.

Click “Start Diagnosis”

Select correct basic vehicle characteristics, click “Adopt”

Click “Without Job”

Click “Address”

Click “Fault memory list”–>”Central Electrics”

After data reading out, click “Control units”–>”Control unit list”–>”0002 Transmission”–>”Guided function”

Click “0002-Basic setting mechatronik”–”Execute”

Read description on the left side, then click “Done/Continue”

Basic setting is required only after the following repairs:

Software adaptation

Replacing mechatronic

Replacing clutch

Event memory entry

Click 2, transmission basic setting

Would you now like to execute the function? Click “Yes”

Follow the steps on the left side, then click continue button to continue with the program

The basic setting has been performed correctly. Click “Done/Continue”

Switch ignition on, then click “Done/Continue”

Click 4, cancel,end program

 

More cases about Skoda, please refer to SKODA TROUBLE REPAIR.