This instruction will show you guide on how to get rid of the engine oil change indicator or warning via DDT4ALL for Renault Trafic, Opel Vivaro and Nissan Primastar. This option is especially useful for those who do not want to reset this indicator by the classical method.
More cases about engine oil indicator, please click to OIL SERVICE INDICATOR RESET.
Procedures:
DDT4all is tool to create your own ECU parameters screens and connect to your vehicle with an ELM327 cable.
Running DDT4ALL, select “X83-TRAFFIC II”–>”UCH”–>”UCH X83-X76-X70-X24_V6.8”,click it
Click “Ecrans de Configurations”–>”Config Tableau Bord Par Liste”
Click “Lire”,then select “Sans montre””BVM””UCH””Sans RVLV””CAL B(95 I,X83)”
ATTENTION: Ignition key must be off!!!
Select “Pas de maintenance”–>”Ecrire” and confirmed
Click here
Waiting for a while, click “Lire”
Exit DDT4ALL, start vehicle and engine oil change indicator is gone.
More Renault cases,please refer to: Renault Trouble Repair.
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…