Here is the instruction show you guide on how to solve Scania truck road transport informatics monitor RTI 260 error.
Related Contents:
2025.09 Scania SDP3 V2.66.3 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2025 2018 Scania Multi EPC Parts Catalogue Free Download
Error identification
The volume button on the monitor is not working.
Cause
The monitor is not working. The monitor cable may be disconnected or damaged.
Notes
If there is nothing wrong with the volume control, this fault code can be disregarded.
Action
Check the monitor cable.
Start up the system using the following procedure:
Exit the program.
Switch off the power.
Press the On/Off button on RTI unit for at least four seconds. (An acoustic signal is heard.)
Wait at least five seconds. Then switch on the power and start the RTI unit.
Where necessary, renew the cable to the monitor. Renewal of cable must be carried out by supplier.
For more information about Scania truck,please refer to:Scania Trouble Repair.
This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…
This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…