This instruction show you guide on how to solve Scania truck motion and inclination detector, calibration fault.
Related Contents:
2025.05 Scania SDP3 V2.65.2 V2.40 Diagnostic Software Free Download
Scania VCI3 Diagnostic Adapter Full Chips
2025 2018 Scania Multi EPC Parts Catalogue Free Download
Error identification
The ALM control unit has detected that motion and inclination detector T78 is incorrectly calibrated.
Cause
Motion and inclination detector T78 has not been calibrated correctly in relation to the ALM control unit.
Faulty software in the ALM control unit.
Fault in motion and inclination detector T78.
Faulty ALM control unit E7.
Notes
–
Symptom
Motion and inclination detector does not work.
Action
Carry out spare parts programming of ALM control unit E7.
Update the software in the ALM control unit.
Renew motion and inclination detector T78.
Renew the ALM control unit.
For more information about Scania truck,please refer to:Scania Trouble Repair.
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…