This instruction show you guide on how to diagnose Nissan Japan ZF transmission accelerator pedal error,CAN-signal error indicator.
Related Contents:
ZF Testman Pro 10.5 Transmission Diagnostic Software Free Download
Diagnostic Procedures:
ZF Failure number: 003
Failure description: Error on ”Accelerator pedal”
Failure detection: CAN-Signal Error Indicator
ZF-internal name: e_ACCPedalPos_ERROR
ZF-internal type: DI_ET_INVALID_SIGNAL
System reaction: ErrorLevel 1
Failure reset condition: No Failure Signal
If failure reset condition is fulfilled: System reaction is reset after ignition off
Signal path: EDCÆ Accelerator pedal
Pertained component: EDC, Accelerator pedal
Failure Number: 003
e_ACCPedalPos_ERROR
Failure Number: 003
e_ACCPedalPos_ERROR
Check Accelerator pedal–>Change Accelerator pedal
Check CAN connection,cable to EDC–>Repair connecting cable
Check Engine Controller -EDC–>Change Engine Controller -EDC
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…