This article is show you guide on how to us FVDI active AMG Logo for Mercedes Benz.
IMPORTANT:
-Save complete variant coding of KI/IC/DASH->maybe necessary
-Save always original Eeprom –>if new Eeprom does not fit you may write the original one back Possibilities:
-Switch a non amg cluster into a amg cluster but you need a new km plate then
-Switch the digital KI/IC/DASH withoit any hardware changes
1Start Mercedes V7.0
2Open special functkions
Choose read/update Confdata
3Choose the write Dash/KI/IC
Read will download the original Dash/KI/IC Eeeprom -PERFOM THIS ALLWAYS Save to file will save the read Eeprom data
4Choose the Bin file you want to write into Dash/KI/IC
5Pressing update will upload the data into Dash/KI/IC
6Message that the upload is completed should appear
7Turn off ignition
8Close door
9Close car
10 Open car
11 DASH/KI/IC should show AMG startup logo
12Three dashes should appear for km—
13Error shpuld appear that DASH/KI/IC is not adapted/tought in.
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…
This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…
This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…