Launch X431:Toyota Accumulator Pressure Down to Zero Drive

This function is located under TOYOTA-ABS-Work Support menu,TOYOTA-16 or CAN BUS II connector must be selected.

 

Launch X431 on Toyota Related Article:

Toyota Crown 2013 All Keys Lost & Remote Programming by Launch X431

Adjust Torque Sensor for Toyota 2006 C1515 Trouble Code by Launch X431

Toyota Yaw Rate Acceleration Sensor and VSC Light Reset by Launch X431

 

And here is a collection of Launch X431 Test Cases:

How use Launch X431 Diagnostic Tool

 

The following is operation procedure:

Operation condition:Accumulator is a store up energy component which is divided into two chambers in ABS system, one chamber is used to store brake fluid, and another is a gas chamber in which is filled high pressure nitrogen gas to keep the brake fluid pressed under specified pressure. On working, high pressure brake fluid in the accumulator is still present, so when replace actuators or maintains ABS system, pressure in accumulator must be released first for replacement or repairs safety. At this moment, this function, Accumulator zero down drive, is necessary.If you decide to perform this function, please click “Accumulator zero down drive” above figure, then enter the following figure, step 1/3, please click ”YES” to continue performing:

On the Step 2/3 figure，click “YES”, the accumulator pressure down to zero drive is performing, the process will spend about 20s, then enter Step 3/3:

The accumulator pressure has been down to zero, please switch ignition to OFF according to the hint on the display, click “OK” to end the function.