FCOM supports so called DTC Freeze frames. Every DTC is assigned variable set of environment data (such as mileage, battery voltage, engine speed, etc) at time of first DTC occurence. If multiple DTCs are present, ECU may record only first DTC freeze frame or only a subset of DTCs may contain freeze frame.
Please note that pre-UDS (ISO14229) ECU freeze frame is mostly limited only to petrol engines. All ISO14229 UDS ECUs usually support freeze frames. Freeze frame contents is determined by ECU for each DTC.
The article shows how to read freeze frame for fault codes stored in BCM ECU. Freeze frame is available only for the first DTC displayed.
Preparations:
FCOM Ford OBD2 Diagnostic Software Download
How to Install FCOM Diagnostic Software on Window/Linux
Procedures:
Plug your FCON interface to vehicle,then run FCOM software
Click “Select Control Unit”
Click “Body” label and select “BCM-Body Control Module”,then click “Go” to continue
Click “Read Fault Code Memory”
Select a stored diagnostic trouble code,then click “Freeze Frame”
Now you can view the freeze data
And you can click go back to view other fault code freeze frame.
This instruction show you guide on how to bleed air from the fuel system for…
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…