This instruction show you guide on how to solve Scania truck auxiliary heater system ATA 112 overheat sensor.
Related Contents:
2024.07 Scania SDP3 V2.61.2 V2.40 Diagnostic Software Free Download
2023 2018 Scania Multi EPC Parts Catalogue Free Download
Scania VCI3 Diagnostic Adapter Full Chips
Overheat sensor
Error identification
The overheat sensor has detected a temperature above 120°C for ATA 1, and above 150°C for ATA 2
Cause
Blocked air supply to the auxiliary heater, cold air.
Blocked air vent from the auxiliary heater, heated air.
Fault in the fuel supply.
Fault on the overheat sensor.
Notes
Action
Check that the pipes for auxiliary heater air supply and air venting are not blocked.
Check the fuel supply.
Check the overheat sensor.
Instructions for the checking procedures are found in the work description in Multi under 18-90 “H13, ATA Auxiliary heater – air”.
For more information about Scania truck,please refer to:Scania Trouble Repair.
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…