How to Replace and Program New BCM for Opel Corsa-D

This mini post show how to the procedures of replace and program new BCM for Opel Corsa-D.

Note:When you are programming,you need to use OPCOM software to perform,download here:Newest OPCOM VAUX-COM All Version Free Download

 

Preparations:

Before you replace the BCM make a note:

• Security Code
• V.I.N.
• Mechanical key number (MKN)
• CAN-High configuration
• CAN-LOW configuration
• CAN-Middle configuration
• Perform a complete diagnostic test and store the results
• Make sure that the V.I.N. matches the vehicle and other installed

 

Install the new BCM

• Perform CAN-High, Low and Middle configuration settings
• Program Immobilizer function, select BCM installation
• Program V.I.N. and mechanical key number in the new BCM
• Match all available keys to the BCM

Perform a reset of these controllers:

o IPC

o BCM

o SDM

Switch off ignition and wait at least 15 seconds

Program Security Code in these controllers:

o IPC

o BCM

o SDM

The new BCM has now been programmed to the car.

Run another diagnostic-test. Clear remaining DTC’s and check if all is working fine.