This instruction will show you guide on how to do oil change for 2010-2015 Mercedes Benz GLK350 4matic. The process is much the same for any Mercedes with the M272 3.5L V6 engine.
What you Need?
Large Multi Purpose Oil Funnel
And here are same topic article on oil change:
Mercedes Benz Sprinter Oil Service Indicator Reset
Procedures:
Car should be warm before draining oil, also a new copper ring for drain plug is needed.
Tools
Oil Filter wrench,Pick,13mm socket,8mm socket,Torque wrench,Funnel
Remove plastic shielding(8mm bolts x 8)
Unbolt oil drain bolt (13mm socket)
Leave to drain while changing oil filter
Remove front engine cover, then remove oil filter housing
Remove oil filter and seal with pick
After clean filter housing, replace new rubber seals and slide on new oil filter, filter used was Mann filter #0001802609
Lubricate seals with oil
Screw in filter housing
Torque oil filter housing to 25NM
Place new copper ring on drain bolt
Torque oil drain bolt to 30NM, then re-attach plastic shielding
Check the owners manual of your car for oil capacity
Fill oil- here we put 7.5 liters
Put everything back, take the car for a drive and warm it up. Check oil after 10minutes- add if needed.
More cases about Benz, please refer to Benz Trouble Repair.
Here show you guide on how to solve Doosan machine Timeout error of CAN receive…
This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…