How to Bleed Brake System for Jaguar XF 3L by G-Scan 2

When you repair bake system or replace brake fluid for Jaguar XF,you need to perform brake bleed.So this function show the procedures on how to use G-Scan 2 diagnostic tool to bleed brake system for Jaguar XF 3L diesel engine.And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.

 

Procedures:

Connect G-Scan 2 diagnostic tool to Jaguar XF by OBD port,then enter menu to select [Diagnosis]

JAGUARE–>Vehicle model:XF–>Year:2010-2011

ABS(ABS Control Module),then select [OK] to continue

Select [Special Function]–>[Brake Bleed]

Switch ignition to ON position [position 2]

Open the rear left wheel bleed screw

Pump the brake pedal during the entire bleed procedure.

Select [OK] to continue

Now press the brake pedal and wait the process…

When you finish the operation,it will show the massage on the screen

Wait until the brake fluid is air and bubble free

Close the rear left wheel bleed screw

Then select [OK] to continue

Open the front left wheel screw

Pump the brake pedal during the entire bleed procedure

Wait…

Wait until the brake fluid is air and bubble free.

Close the front left wheel bleed screw.

Open the front right wheel screw

Pump the brake pedal during the entire bleed procedure

Wait about 3 minutes to process complete

Wait until the brake fluid is air and bubble free.

Close the front right wheel bleed screw.

Open the rear right wheel bleed screw

Pump the brake pedal during the entire bleed procedure.

Wait…

Wait until the brake fluid is air and bubble free

Close the rear right wheel bleed screw

Now turn the ignition to OFF position,then press [OK] to continuef

Completed successfully