This instruction shows guide on retrofitting external temperature sensor to Fiat Grande Punto 2005-2012 by FiCOM. First we read fault codes to show no DTCs are present. Then external temperature sensor is configured. When configuration is saved, body computer displays DTC showing error(as the sensor is no yet connected)
Preparation:
FiCOM For Fiat/Alfa/Lancia Diagnostic software Free Download
How to Install and Quick Start FiCOM Diagnostic Software
Procedures:
Click “Select Control Unit”
Choose the correct vehicle model, click “Go”
Click “Body”–>”Body Control Module(BSI)–”Go”
Click “Read Fault Code Memory”
And find there is no DTCs, Click “Go Back”
Click “Configuration”
Scroll down and find the statue of External Temperature Sensor is Absent, Select it and click “Edit”
Change statue to Present, click “Continue”
Click “Write Configuration to ECU”
Click “Yes”
Configuration was successfully written to the ECU. Click “OK”
Go back to main menu to read fault code memory again
And find fault code “B1027-12 Out side air temperature sens”. Click “Freeze Frame”
Click “Go back”
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…