OLYMPUS DIGITAL CAMERA
This illustration show you guide on how to repair HINO 600 series truck P060C DCU malfunction.
Related Contents:
2024.03 HINO Diagnostic Explorer DX3/DX2 Diagnostic Software Free Download
HINO Trucks EPC Electronic Parts Catalog 2018 2016 Free Download
Preparations:
1Connect the vehicle to HINO DXⅡ.
2.Set the starter switch to the “ON” position.
3.Select [DCU] and check if HINO DXⅡ is communicating with the DCU.
4.Erase the malfunction history.
5.Set the starter switch to the “LOCK” position.
6.Check if the DCU main relay is OFF in the HINO DXⅡ menu. (This cuts off the communication between HINO DXⅡ and the DCU.)
NOTICE
The main relay turns OFF 1 minute after the exhaust gas temperature (SCR inlet) drops below 200 °C {392 °F}.
7.Set the starter switch to the “ON” position.
8.Select [DCU] and check if P060C has been detected.
Has DTC P060C been detected?
Yes,replace the DCU.(After replacing the DCU,perform a DPR forced regeneration)
Perform “After-inspection work” of INFORMATION section
No,Erase the malfunction history and re-check the DTC
Perform “After-inspection work” of INFORMATION section
This instruction show you guide on how to solve Doosan and Bobcat Electric problems can…
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…