This article show the procedures on how to use FCOM to configure/program Ford Focus cruise control unit.
Preparations:
FCOM Ford OBD2 Diagnostic Software Download
How to Install FCOM Diagnostic Software on Window/Linux
Ford Vehicle Mode Covers:
Ford Focus 2010- ,Ford C-Max 2010-, Ford Fiesta 2008-, Ford Transit 2006-,Ford Transit Custom 2013-, Ford Transit Connect 2013-,Ford Mondeo 2006-2015, Ford Galaxy 2006-2015,Ford S-Max 2006-2015
Procedures:
Select “Settings” in the Miscellaneous functions
Tick “Development functions” and then click “Save Changes”
Click “Select Control Unit”
Select “BCM-Body Control Module”,then click “Go” to continue
It will take several seconds to build communication to BCM
Select “Configuration”
Select “Control Unit Configuration”,then click “Go” to continue
Communication in progress…
Select “Cruise control”,then click “Edit”
Select “Present” option,then click “Continue”
Click “Write configuration” to ECU
It will prompt you with below massage,please click “Yes” to continue
Communication in progress…
Programming configuration…
Configuration was successfully
Done!
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…