G-scan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011

In this article,G-scan2 test the G-Scan2 diagnostic tool BMW DME special function on BMW 302I 2011.And for more G-scan2 diagnostic tool test report,check here:G-scan2 test report

 

Procedures:

Connect G-Scan2 to the BMW 320I,and the select “Diagnosis” menu and then select BMW 320I 2011 model.

After then select “DME(Digital Engine Electronic)”,click “OK” to continue

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (1)

Select “Special Function”

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (2)

Select “Clear adaptations”

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (3)

The adaptation values can be reset in the next test step,click “F1” to start resetting adaptation values.

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (4)

Then i will show you adaptation values were reset.

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (5)

Switch off terminal 15 and terminal R

Wait 15 seconds until the reset adaptation values and variants are stored in the DME,then press “OK” to continue

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (6)

Switch on terminal 15

Leave ignition switched on for at least 10 seconds,press “OK” to continue

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (7)

Service function finished

Gscan 2 Diagnostic System Reset Adaptation Values for BMW 3 Series 320I 2011 (8)

 

Visited 1 times, 1 visit(s) today