Several days ago,I read a post on the forums about how to program BMW F-series FA.It is very useful for bmw coding learner,in the information the thread provided,you can know how change your BMW F-series FA.So I rewrite it here,and hope it can help you my friends.
Tool you need:
BMW ENET and BMW F-series coding software E-sys.
Here come the easy step by step on How to program bmw f series fa.
Step 1. Start E-sys program, and connect to car by clicking icon at the top.
Step 2. Select your car, and click connect. Select interface depending on interface you will be using. If you use ENET cable then select connection via VIN at the bottom.
Step 3. Go to expert mode > coding. Click read under vehicle order to read FA from car. Click edit.
Step 4. Screen will automatically change to FA-editor. Right-click on FA, and choose “calculate FP”.
Step 5. Once finished, vehicle profile is shown on right. Expand FA List on left, to SALAPA-element.
Step 6. Delete/add FA from the bottom left window, and click apply changes icon.
Step 7. New FA must be verified before it can be written to car. Right-click FA and calculate FP again. If FA entered is wrong, error will be shown. For example, “DDD” is not correct FA and E-sys will display error message. After FP is calculated, save the new FA.
Step 8. Go to Expert mode > VCM. Load your saved FA file, right-click on FA and calculate FP again.
Step 9. Click VCM master tab, and click write FA FP. New FA will be written to the car.
Step 10. Click “read FA FP VIN” button and check FA to make sure changes are saved to the car.
That’s all, It only takes a few minutes to do the job.