Categories: Auto Repair

Volkswagen Passat Flameout Suddenly And Can Not Start Engine

This post show a real auto repair case on Volkswagen Passat flameout trouble.A VW Passat owner called our technicians about the trouble his Passat flameout suddenly and can not start the engine again.

 

Related Content:

Volkswagen Passat Trouble Repair

Volkswagen Trouble Repair

 

 

Vehicle info:

Model: Volkswagen Passat

Year:2001

Mileage:about 240,000 miles

 

Trouble symptoms:

Flameout suddenly

Can not start the engine again

 

VW Passat Flameout Analysis & Dianosis:

Our technicians tested the Passat found that the engine can be start normally,but engine off when hand leaving the ignition key.And found the DTC 17978–Engine Start Blocked by Immobilizer.But there are not DTCs exit in the immobilizer system.

 

According to the vehicle testing resault,the fuel and ignition system trouble result in engine flameout can be ruled out,it most likely that the flameout trouble caused by ECU problem.

 

Firstly,technicians detected the power voltage of ignition,use multi-meter to measure the voltage of ignition coil when turning the igniiton,the voltage value is normal.

 

Next,technicians measured the voltage of injector,it showed only 8 volt,lower than normal value.But detected the wire harness between injector and ECU,all of them are normal.So technicians measured the voltage of :Hall sensor,oxygen sensor,crankshaft position sensor,all the voltage value of them are lower than normal value.

 

Further measurements revealed that the output voltage of the ignition was low,and the supply volate was normal only when the ignition was in the start position,which explains why the engine can only be start when starting.It means the ignition switch caused the engine flameout trouble.

 

Troubleshooting

Replace the ignition switch,then the VW Passat can be started correctly.

auto

Recent Posts

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

5 days ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 week ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

3 weeks ago

How to Solve Caterpillar C9 Vehicle Speed Signal Invalid?

This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…

4 weeks ago

Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test

Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…

4 weeks ago

JCB 200X Series Machine Reduced Power Mode Engine Derate

JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…

1 month ago