Many auto locksmiths want to get the high-efficient method of Toyota G chip all key lost programming, no need removing parts.So here comes a guide on Toyota RAV4 G chip all key lost programming by OBDSTAR X300 DP PAD via OBD.
Device: X300 DP tablet key programmer full version
Master key and sub (G) key
G chip key
Connect X300DP with your vehicel through OBDII Port
Click “Diag Program” on the main menu
Choose “Type 2(with G72)”
Choose “Remote immobilizer(All key lost)”
Then switch ignitino off
Click OK to continue
Switch ignition on
Click OK to continue
It will prompt you to switch ignition off and remove the key
After doing that, click OK
It is configuring the system, wait for a while…
Then insert the removed key and switch ignition on
It is configuring the system, wait…
Switch ignition off and remove the key again
Then you should program keys as the following steps within 120 seconds:
A Program 2 master keys and 1 sub keys
1 Insert the first master key,turn on the ignition,and wait for 5 seconds.
2 Insert the second master key,turn on the ignition,and wait for 5 seconds.
3 Insert the third sub key,turn on the ignition switch,and wait for 5 seconds.Security light turn off,and programming is finished.
B Program 1 master key and 1 sub key.
1 Insert the first master key,turn ono the igniton,and wait for 5 seconds.
2 Insert the second sub key,turn on the ignition switch,and wait for 5 seconds.
3 Turn ono the ignition switch quickly for 5 times.Security light turns off,and programming is finished.
C Program 1 master key
1 Insert the master key,turn on the ignition switch,and wait for 5 seconds.
2 Turn on the ignition switch quickly for 5 times.Security light turns off,and programming is finished.
Here we program 1 master key and 1sub key.
Click OK to begin program keys
Step1: Insert the first master key, turn on the ignition and wait for 5 seconds…
Step2: insert the second sub key (the G chip key), turn on the ignition switch and wait for 5 seconds
Step3: turn on the ignition switch quickly for 5 times, the security light will turn off, the programming is finished.
Done! Program key for 2013 toyota RAV4 with G successfully!
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…
This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…
This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…
Here is the instruction show you guide on how to do Advanced Tool Select and Basic…
Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…
AGCO EEM Dosing module Description The dosing module (DM) is installed in the exhaust…