This show the guide on how to install &retrofit BMW X3 angel eyes.I will introduce the procedure step by step with picture and text.Hope this article will bring some enlightenment to your own work.
Procedures of BMW X3 Angel Eyes Installation & Retrofit:
Step 1 is to obtain a good power source for the Angel Eyes. Below is a picture of the ECU. Here I tapped into the accessory power supply. This is what makes the angel eyes light up when the key is turn to position 2.
Relay, 12V power and ground.
Everything wired. Fingers crossed. It works!
Back of headlights
Everything removed from headlights.
I was scared shitless during this part. Headlight housing apart after baking in oven @ 200F
Amber reflector removed.
I used siliconII (operating temperature up to 400F) to glue on the angel eyes.
Housing back togeather. No more ugly amber reflector!
BMW X3 angel eyes installation & retrofit complete!
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…