This instruction show you guide on how to use Super Pro 610 programmer to reset Toyota Corolla 2012 airbag.And for more airbag reset cases,please check here:Airbag Reset Projects.
First use Launch X431 diagnose Toyota Corolla,find below diagnostic trouble code:
B1901 Open in P/T Squib (RH) Circut
B1906 Open in P/T Squib (LH) Circut
B1901 Open in P/T Squib (RH) History Cicuit
B1906 Open in P/T Squib (LH) History Circut
Locate the airbag module,connect two wires and remove airbag module
Toyota Airbag module:
89170-02B20
231000-5850 12V
Disassemble the airbag module shell,remove the PCB and locate the airbag chip 93C56
Install 93C56 chip on Super pro programmer and run software to select 93c56 chip type
Read 93C56 chip data and reset,then write back.
After then install airbag module back on Toyota Corolla,test if the warning light go off.
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…