Remove and Install Front Oil Seal for Komatsu PC130-8 Excavator

This post focus on step-by-step guide on how to remove and install front oil seal for Komatsu PC130-8 excavator.For more Komatsu case,please refer to:Komatsu trouble repair.

 

All workshop manuals and parts you can get it here:

Komatsu CSS Full Set 2018 2014 Parts Viwer Free Download

 

What Tools Need?

 

Procedures:

Removal

1.Remove the engine assembly, referring to “Removal and installation of engine assembly.”

2.Remove alternator mounting bolt (1).

3.Loosen fan belt adjust bolt (2) and remove fan belt (3). [*1]

4.Remove engine speed sensor connector (4).

5.Remove speed sensor mounting bolt (5) and remove speed sensor (6). [*2]

6.Remove crankshaft pulley mounting bolt (7) and remove crankshaft pulley (8). [*3]

7.Remove front oil seal (9).

 

Installation

Use tool A1 (outside diameter of 80 mm) to press front oil seal (9) in gear case (10).

1) Check the crankshaft end corner and the oil seal lip sliding surface for flaws, burrs,scars, or rust, before installing the oil seal.

2) Fill about 2 cc of grease to between the oil seal lips.

Front oil seal: grease (G2-LI)

Install the crankshaft pulley.

Align key (a) of crankshaft (11) with key groove (b) of crankshaft pulley (8) and install the pulley.

For the rest of the installation work, carry out the installation in the reverse order of removal

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

3 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

1 week ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

1 month ago