This instruction show you guide on how to use Launch X431 to reset oil service light for Maserati M156C 2014.And for more Maserati projects,please check:Maserati Trouble Repair.
What You Need?
Preparations:
1.Park your car on the level surface. The installed sensor is very sensitive to the tilt of the vehicle,Otherwise, it will display an error measurement tolerance.
2.Gear selector in the P mode in car position.
3.After running the engine, waiting for 10min until all vehicle run indicator reach stable. The sensor signals used at this time will give the correct output.
Operation instructions
1.Switch on the ignition ;
2.Select European;
3.Select Maserati V10.02 above
4.Select “QUATTROPORTE”
4.Select M156
6.Select gasoline
7.Select system scan
8.Select IPC-Dashboard
9.Read ECU information, Select”Yes”
10.Select special function
11.Select”reset”
12.Note the “reset” prompt information ,ensure correctly set the date of the dashbord
13.After confirm,prompt program is finished
More test report about Launch X431 please check:Launch X431 Test report
This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…
This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…