This instruction show you guide on how to solve JCB StageV Tier4 engine air filter pressure sensor active at init state SPN 107,FMI 31.
Related Contents:
WinEEM4s JCB Service Tool 2.7.2 2.6.1 Free Download
2024 JCB ServiceMaster 4 v24.3.1 Free Download for Win 10 Win11
2017 JCB Parts Plus+ and Repair Service Manual Free Download
Description
The air filter pressure sensor indicates blocked filter even though engine is not running.
Possible causes are:
The air filter pressure sensor wiring is defective.
The air filter sensor is defective.
Reaction in EEM
The FC is stored and the warning lamp is activated. The CAN message indicates active fault.
Solution
First save the error log and then erase it. Restart the ECU after erasing the error log. If the fault occurs again during the next driving cycle, check the following paths:
Check the air filter pressure sensor wiring, the connectors and the contact surfaces of the connector pins (possible oxidation).
Check the operation with another air filter pressure sensor to see if the air filter pressure sensor is defective.
More repair case for JCB,please refer to:JCB Trouble Repair
Here is the instruction show you guide on how to solve Doosan engine P0087 SPN…
This instruction show you guide on how to solve PCC1302 PowerCommand remote emergency stop activated.…
This instruction show you guide on how to use Launch X431 XPROG 3 programmer to…
This instruction show you guide on how to replace engine rotation speed sensor crankshaft for…
This post show you guide on how to install evaporator for CLAAS Lexion 480 combine.…
This instruction show you guide on how to solve Bobcat engine DCU P1A32 Self-Diagnostis in…