This post show you guide on how to install evaporator for CLAAS Lexion 480 combine.
Related Contents:
CLAAS CDS 7.5 Diagnostic Software 2021 2020 Free Download
CLAAS USB Interface Diagnostic Adapter Package
Procedures:
1 Insert evaporator (23) into the cab roof.
2 Push expansion valve (14) with new O-rings on the connections of evaporator (23) and bolt down
support plate (C).
3 Push suction line (12) and discharge line (16) with new O-rings into the expansion valve (14) and bolt down support plate (B).
4 Guide capillary tube (C) of the temperature switch (9) through the cab covering, bend a 90°
angle approx. 80 mm from the end and carefully push it into the evaporator (23) at (X and Y).
(X) = 60 mm
(Y) = 30 mm
5 Glue on sealing plate (5).
6 Seal pipe leadthrough with sealing compound (B).
7 Screw down the cover (A) to the cab top.
8 Air conditioning system – Topping up refrigerant,
More repair case for CLAAS,please refer to CLAAS Trouble Repair
This instruction show you guide on how to solve IDSS diagnostic adapter lost communication to…
This instruction show you guide on how to use SerDia2010 to perform input test A55…
Here is the instruction show you guide on how to solve Doosan engine P0087 SPN…
This instruction show you guide on how to solve PCC1302 PowerCommand remote emergency stop activated.…
This instruction show you guide on how to use Launch X431 XPROG 3 programmer to…
This instruction show you guide on how to replace engine rotation speed sensor crankshaft for…