It is necessary to register recognition code when replace door control transmitter or door control receiver.So here i will share how to use Toyota TIS Techstream to register recognition code.Hope it helps!
Note:For detail procedures,refer to the prompts on the Techstream screen.The number of currently registered codes can be checked on the first screen of Wireless Code Registration.
Preparations:
Toyota TIS Techstream Video+PDF Tutorial
Latest Toyota TIS Techstream V13.10.019 Software Free Download
Toyota TIS Techstream v12.20.024 Installation Guide
How to use Toyota TIS Techstream
Procedures of Recognition Code Registration:
1.Turn the ignition switch to ON
2.Enter the following menus:Body Electrical/Main Body/Utility/Wireless Code Registration
3.Press both the lock and unlock switches at the same time for 1 to 1.5 seconds.
4.Press either switch for more than 1 seconds within 3 seconds.
5.Check the response to the registration completion.
Response to Registration Completion:
Main body ECU automatically performs power door lock-unlock operation to show whether registration has been completed correctly or not.
If the lock-unlock operation occurs twice,the registration of the recognition code has failed.Perform the registration procedures again from the beginning.
If registering another transmitter,repeat the procedures after the Techstream operation.All 6 recognition codes can be registered consecutively.
6.Perform either of the following to complete the registration of the recognition codes:
Use the Techstream to send a completion command.
Disconnect the Techstream.
Done!
Magneti Marelli 49FB – Fiat ECU Pinout More ECU PINOUT Components: ECU Modules Repair…
After ECU reparogramming,it is necessary to write new engine number and machine ID into ECU.So…
PCC1302 PowerCommand Low Coolant Level (Warning or Shutdown) Solution Related Contents: 2024 InPower V14.5…
The function identifies the exhaust temperature and indicates malfunction in the exhaust system. The evaluation…
MTU DiaSys diagnostic software is professional on MTU engine diagnostics and programming.But seems that is…
This instruction show you guide on how to use JPRO Diagnostic to do aftertreatment injector…