In this instruction,G-scan 2 tech team SCOTT show us how to use G-scan 2 diagnostic tool to initialize Slide Tilt sunroof for BW X3 2015.And for more G-Scan 2 test report,please check here:G-Scan 2 Test Projects.
Procedures:
Connect G-Scan 2 diagnostic tool to BMW X3 OBD port,then enter menu to select [DIAGNOSIS],then select [BMW]–>[X Series]–>[X3(F25) (2010-present)]
Select [Body]
Select [FZD (Function center/roof)] and press [OK]
Go to [Special Function]
Select [Initialise slide/tilt sunroof],it is used when you replacing or repairing sunroof,you may carry out this function
Important:
The slide/tilt sunroof is moved when initialisation is selected
F1:Carry out initialisation
F2:End service function
Here select [F1]:Carry out initialisation
Note:
Switch terminal 15 and terminal R off and on again!
Otherwise,initialisation may not be carried out correctly
Switch off and on again,then click [OK] to continue
Now in progress
Initialisation completed successfuly without errors.
This is all done for initialising slide/tilt sunroof
This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…
This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…