If your Lexia Diagbox firmware is old version,maybe 4.3.0,it can not work on PSA new vehicle model.It must to be upgrade the firmware for Lexia Diagbox to make it work on new cars.Here is guide.
Preparations:
PSA Interface Checker Download,Installation,How to Use and Feedback
APPLI_XS_Fuji from 2.0.1 to 4.3.7 version download here
Procedures:
Connect Lexia Diagbox PP2000 interface to PC via USB,then run PSA Interface Checker.
Note:Make sure you have install driver for Diagbox,and PC have identify your interface.
Then click “ACTIVATE” button,then click “Version” button.
PSA Interface Checker will show your Lexia Diagbox firmware version
Click “Reference” button,and show you with 921815 C version
Click “Select File” button to load the APPLI_XS_Fuji file
After then click “Downloading” button to starting upgrade
When the upgrading job done,it will show you with OK message
Now close PSA Interface Checker software,and click “Version” and “Reference” button to check new version firmware valid.
How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…
Here show you guide on how to solve Doosan machine Timeout error of CAN receive…
This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…
This instruction show you guide on how to solve Doosan machine trouble code U043D message…
Here is the instruction show you guide on how to solve AGCO machine trouble code…
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…