How to Setup Connection Between DTS Monaco and MB SD C4 DoIP

After Benz DTS Monaco software installation,you need configure DTS Monaco for interface (here take MB SD C4 DoIP as example).So here car-auto-repair.com show you guide on how to setup connection between DTS Monaco and MB SD C4 DoIP.

 

Preparations:

Benz DTS Monaco 8.16 8.08 Software Free Download

How to Install Mercedes Benz DTS Monaco 8.16 Software

 

Procedures:

After DTS Monaco installation,open network and sharing center

Click “Change adapter setting”

Right lick “Local Area Connection” and select “Properties”

Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”

Select “Use the following IP address”,and set address as below:

IP address:172.29.127.35

Subnet mask:255.255.255.0

Then click “Advanced…”

Click “Add”

Set address as below:

IP address:169.254.0.35

Subnet mask:255.255.0.0

Then click “Add”

Click “OK”

Click “OK”

And close

Now right click “Wireless Network”,then select “Properties”

Select “Internet Protocol Version 4 (TCP/IPv4)”—>”Properties”

Select “Use the following IP address”,and set address as below show

IP address:192.168.2.35

Subnet mask:255.255.255.0

Then click “OK”

Click “Close”

Now right click “SDconnect Toolkit” at lower right corner to select “Administration”

Click “Register/configure” option

It will show you the information as below.

Check off the “WLAN parameters,workshop” option

Select “Encryption” type to “WEP/Hex”

And set a Key:aaaaaaaaaaaaaaaaaaaaaaaaa

After then click “Start”

After finish it will show you a configuration information,close it.

And exit SDconnect Toolkit

Now you can run DTS Monaco with MB SD C4 DoIP.

auto

Recent Posts

How to Solve Liebherr Machine Power or Speed Reduction?

How to solve Liebherr machine trouble code P1188 power or speed reduction emission related failure.…

6 days ago

Doosan Machine Timeout Error of CAN Receive Frame AUXIO1

Here show you guide on how to solve Doosan machine Timeout error of CAN receive…

2 weeks ago

Liebherr Machine Emergency Stop-Ignition on While Emergency Stop is Active

This instruction show you guide on how to solve Liebherr machine emergency stop ignition on…

3 weeks ago

How to Solve Doosan Machine U043D CAN Receive Frame Counter Error

This instruction show you guide on how to solve Doosan machine trouble code U043D message…

4 weeks ago

AGCO Machine Trouble Code SPN 1485 – FMI 03 Solution

Here is the instruction show you guide on how to solve AGCO machine trouble code…

1 month ago

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

2 months ago