Categories: Auto Repair

How to Replace Water Pump for Toyota Camry

Water pump control the coolant flow through your Toyota Camry engine and radiator.Water pump make coolant flow circulate inside engine and keep engine work on normal temperatures.

 

It is a important part of engine,sometime you hear a lot of noise at all RPM’s from engine,and the coolant reservoir was dropping,it mean there was a mild leak.So you need to replace a new water pump for your Toyota Camry.

 

How much it cost you to replace water pump?

Here collect some Toyota Camry water pump replacement price from Toyota Camry customers

Surfslinger: My first dealer quote was just shy of $500, which seemed a bit high to me.

Punks_Not_Dead5: i paid just over 700 for the water pump and timing belt (i have a V6)..when i go out to my car i’ll look to see how much the water pump cost, and give a rough estimate on the labour.

CharmCityES: labor time for customer pay water pump is 1.4 hours… part should be like $150.00…plus the cost of the coolant it all depends on what the dealer’s hourly rate is etc….somwhere in the $400 range seems about right, but $500 seems excessive…id look into where and what theyre charging you for before you get it done.

A water pump replacement starts at around $300 and can increase to $800+

 

How to Replace Water Pump?

Water pump replacement 2002-2011 Toyota Camry 2.4L

 

How to Replace Timing Belt and Water Pump 92-01 Toyota Camry

 

How to Replace the Water Pump 2.2L Toyota Camry 1997-2001

auto

Recent Posts

Detroit DD13 J1939 Wheel-Based Vehicle Speed Sensor Signal Missing

Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…

4 days ago

How to Solve Caterpillar C9 Vehicle Speed Signal Invalid?

This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…

1 week ago

Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test

Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…

1 week ago

JCB 200X Series Machine Reduced Power Mode Engine Derate

JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…

2 weeks ago

Liebherr ECU2 D966 D9512 Engine P1162 Fault Code Solution

Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…

2 weeks ago

AGCO EEM5 DEF Suction Module Tank sensor (CAN)

AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…

3 weeks ago