This instruction will show you guide on how you can service the hybrid fan filter on 2020 Toyota Corolla. This service applies to all Corolla hybrids 2020+.
Here is another article about fan filter replacement: How to Replace the Hybrid Battery Fan Filter for 2010-2015 Prius Toyota.
Before replacement, we need to know where is the filter. It is located underneath the passenger rear seat.
Steps:
Use a phillips screwdriver to remove the clip. Since it’s plastic screw, you don’t put too much force into it.
Once it starts coming out a little bit, pull it out
Use a plastic trim tool or other small flat head tool to pop the cover off, start from the clip direction
You can find the filter on the backside
The filter is reusable, you can vacuum it out , blow air through it or you can replace it. The part No. Is G92DH-12020.
After cleaning or replacement, put everything back.
More case about Corolla, please refer to TOYOTA COROLLA REPAIR.
Here is the instruction show you guide on how to replace fuel tank breather filter…
FENDT 900 Vario COM III tractor Component B092 - Sensor, charge air pressure/temperature reports the boost…
Deutz EMR3 Engine Trouble Code 87 / 97 / FlFCD WATER IN FUEL Solution Error description…
This instruction show you guide on how to perform hydraulic flow test for Kubota L3301…
This instruction show you guide on how to configure Lane Departure Warning for Bendix AutoVue…
This instruction show you guide on how to solve AGCO machine SPN102 FMI03 boost pressure…