How to Replace Cornering Light Bulb for Mercedes Benz by Yourselves

This instruction will show you guide on how to detail replace the cornering light bulb on a Mercedes Benz by yourselves. Cornering light is a feature that happens only during at night, because that’s when the corner light gets activated whenever it take a left turn or the right turn or when using the turn signals.

Here is same topic about cornering light and bulb replacement article for further reference:

How to Activate Cornering Lights via Fog Lights with VCDS for Seat Leon

How to Replace LED Headlight Bulbs for Mercedes ML320 2003

 

In our car(Mercedes W212 2011), the moment the left turn signal is activated, it immediately throws an error code to say that check left cornering light.

So how to fix it? Let’s do it.

 

Steps:

Replacement from passenger side

Removing two screws that holds cable

Take the round cover off by rotate in it counterclockwise

Look deep inside and find this is the connector this holds a bulb in place

Reach down there and rotate that black plastic part counterclockwise

Notice how the metal clip is pointing upwards, it will become important the moment you’re going to put it back in place

Once you rotate it just a little bit, it will pop up this place

Here it is completely out

Wiggle it out of the place.

Notice it’s very important when you handle brand new light bulb in order to preserve the lifetime of a bulb you must wear gloves.

Push new bulb in back in place

Make sure the direction of the metal clip is pointing upwards when putting the light bulb back in place

On the driver side bulb, you repeat the same procedure as you did in passenger side .

 

Kevin

Recent Posts

Liebherr ECU2 D966 D9512 Engine P1162 Fault Code Solution

Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…

21 hours ago

AGCO EEM5 DEF Suction Module Tank sensor (CAN)

AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…

4 days ago

How to Remove Threshing Drum for CLAAS Lexion 480 Combine

This instruction show you guide on how to remove the threshing drum for CLAAS Lexion…

6 days ago

Hitachi ZX890-7 Excavator Service Menu Display

This instruction show you guide on how to display service menu for Hitachi ZX890-7 excavator.…

1 week ago

JCB 200 Series Excavator ATS Setup and Calibration Procedure

Here is the instruction show you guide on how to do Advanced Tool Select and Basic…

2 weeks ago

How to Solve Liebherr D966 D9512 Trouble Code P1161 Resistance Error

Here car-auto-repair.com show you guide on how to solve P1161 trouble code on resistance error…

2 weeks ago