This instruction will show you guide on how to do steering curve flashing for ZF steering on VW by ODIS Engineering.
During flash, pls note:
Fully charged battery and external
The Bluetooth connector is firmly connected to the OBD and uses a USB data cable
Do not move hardware and switch keys during refresh
Preparation:
Newest ODIS-E Engineering 17.0.1/12.2.0/9.0.1 Free Download
08.2023 VW ODIS 23.0.5 & 7.2.1 & 5.2.7 Diagnostic Software Free Download
Procedures:
Running ODIS Engineering, Select “0044- Power Steering System”–”Flash”
Select all files
Select “205 Curve” to test steering force.
And we found steering force didn’t change too much
After Steering Curve flashing, Select “Function configuration” –>”flash(engineering”, remove two ticks and save)
Turn off and turn on the ignition switch
Check the steering system
Now we flash Curve 205 to 239.
239 curve features is low speed, extra light, high speed,it is heavier.
Function is ready.
This instruction show you guide on how to do deactivation test for MANITOU MT6034 telehandlers…
This instruction show you guide on how to solve Liebherr machine ECU2 P1119-00 trouble code…
This instruction show you guide on how to solve Bobcat machine trouble code P18A5 suction…
The measured intake manifold pressure (signal from boost pressure sensor) is below the warning limit…
JCB 3CX 4CX Backhoe Loader engine throttle cable is routed from the L.H. side of the…
Here is the instruction show you guide on how to replace fuel tank breather filter…