If your engine light is on and get a error cord P0339 on your Jeep JK Unlimited Rubicon 2013, replace crankshaft position sensor may fix this problem. This instruction will show the procedure of replacing the crankshaft position sensor. If you want to know more cases about Jeep, please refer to Jeep Trouble Repair.
Steps
Find crankshaft position sensor underneath on the passenger side
Taking out the 10 millimeter bolt
Disconnect the sensor, twist and pull out the sensor
Put a new sensor in it
Screwing the 10 millimeter bolt in, connect the sensor
Start the car and find there is no trouble code show up.
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…