How to Coding for BMW E-series Footwell Module (FRM) by X431

In this article I will share the guide on BMW E-series 2010 FRM coding.At beginning of article I instruct the method by text and picture.If you have any doubt after reading,you would better to watch the video guide at end of article.Hope it is helpful to you…

 

Here are some article about FRM(Footwell module) topic,maybe you need them:

How To Upgrade BMW FRM1 To FRM2 or FRM

BMW FRM Module Reset: Short Circuit Counter

How to Remove BMW FRM Footwell Module

BMW FRM Module Repair Guide (Not Need Replacement)

BMW Coding/Flashing/Progrmming PDF+Video Guide

 

Some readers ask me for BMW FRM Dump bin file collection,here i you can download it here:
BMW FRM Dump Data File Download

Device you need to coding for BMW E-series Footwell Module:

Here I take the operations of X431 Pro as example,and you also can do this with other device by local aftermarket or online shopping.

 

Procedures of BMW FRM Coding:

Connect X431 Pro to vehicle,and enter the menu select “BMW”==>Select “Confirm” at lower right corner.

Processing…Please wait…

Select “Confirm” again

Select “Coding/Program”

Select car model“3-series”

Select “3’_E90/E91/E92/E93”

Select “Coding”

Select the replaced system “Footwell Module(FRM) is just repaced”

Reading vehicle data… wait please

Select “Coding system list”

Please check VIN

Reading vehicle data…Wait please

Select “NFRM:FRM(Footwell Module)”

The software will display vehicle order please select “Feedback”

Select “Recoding”

Perform below operations show at software:

Information:

• Turn off ignition
• Wait 15 seconds
• Turn on ignition
• Code control unit

Do you do recoding right now?

Select “YES”

Recoding…please wait

Recoding has been completed

Done!

Video guide on How to Coding for BMW E-series Footwell Module (FRM)