This article show you how to do injection quantity compensation function by G-scan2 for BMW 750 LI 2011 with V8 engine.
Procedures:
Connect G-Scan2 to vehicle by OBD port
Enter vehicle selection menu to select “DME(Digital Engine Electronics)”–>”7 Series”
Press “OK” to continue
Go to “Special Function”
Select “Injection quality compensation”
It will ask you “Was a new DME installed?”
If yes,press “Yes”,if not,press “No”,here press “No”
Pairs of matching values currently stored:
F1:Cylinder 1: 577 214
F2:Cylinder 2: 573 228
F3:Cylinder 3: 572 203
F4:Cylinder 4: 573 239
F5:Next
For what cylinder is a new value to be entered?
This BMW is V8 engine,so select “F5” to see cylinder 5 to cylinder 8
And here you can press “F1-F4” to enter a new value to cylinder you want.
Done!
Video Guide here:
Detroit DD13 EPA10 (2010-13) trouble code SPN 84 FMI 13 (MCM) J1939 Wheel-based vehicle speed…
This instruction show you guide on how to solve Caterpillar C9 engine trouble code 36…
Kubota L3301 L3901 Excavator Safety Valve Setting Pressure Test Using Injection Nozzle Tester 1 Remove…
JCB Engine Fault Derate When a fault is detected, the ECU determines the severity of…
Here is a instruction show you guide on how to solve Liebherr ECU 2 D966…
AGCO EEM5 DEF Suction Module Tank sensor (CAN) The DEF suction module with the CAN-bus…