This illustration show you guide on how to disassemble DAF truck AS-Troninc Lite 6AS1000 Transmission automation module.
Related Contents:
DAF Davie XDc II Runtime 5.6.1 Software Free Download
Procedures:
Cable harness connector allocation 25.010:
E28 Level switch connector
E4 Clutch actuator connector
E2 Transmission cable harness connector
E31 Mount travel sensor connector
E30 Select travel sensor connector
E32 Input speed sensor connector
1 Remove clip 01.534.
2 Unlock and unplug connectors E30, E31, and E32.
3 Remove screw 01.530.
4 Remove shackle 01.520 and toothed washer 01.524.
5 Unlock and unplug connector E28.
6 Remove screw 01.510.
7 Remove clamp 01.500.
8 Remove cable clip 01.670 and 01.690.
9 Unlock and unplug connector E2.
10 Remove screw 01.620.
11 Remove clamp 01.610.
12 Unlock and unplug connector E4.
13 Remove remaining cable clips on cable harness if necessary.
14 Remove the cable harness from the transmission.
More repair cases for DAF truck,please refer to:DAF Truck Repair
It is necessary to do driver installation for JCB DLA 2.0 diagnostic kit,otherwise it can…
Here is the instruction show you guide on how to solve Deutz EMR3 engine fault…
This instruction show you guide on how to solve AGCO machine trouble code 138 SPN…
Here is the instruction show you guide on how to install the left-hand drum bearing…
This instruction show you guide on how to remove and replace loader lift ram for…
This instruction show you guide on how to solve Caterpillar C9 engine 31 84-1 fault…